A good RDA is vital when you are learning how to build. Starting out with a hard to build on RDA will sometimes completely turn you off to wanting to learn how to build.
These RDA’s were picked for
- Easy of use
The Velocity RDA is a superb RDA to start building with. The build deck is wide open. The two posts tower over the deck giving you all the space in the world to build.
The wire is held in place with 4 hex bolts that are less likely to strip then some philips bolts of the similar quality.The 6.5mm massive juice well will make sure you can vape for a while without needing to drip again.
- Stainless steel Construction
- 28mm X 22mm
- Dual Post Design
- Dual Screw Positive Post (aka no center post)
- Massive 6.5mm Juice well
- Split Cap Design
- Fully Adjustable Indirect Air Holes
- Infinite Direct/Indirect Air Flow Adjustment
- Solid Copper Center Pin
Pick up a Velocity RDA by Tobeco for around $16.00
Mutation X V4
The Mutation X Series of RDA’s has been around and one of the most popular and well loved RDA for a while now. The build deck on the Mutation X V4 is open and easy to build on. Not as wide open as the Velocity RDA but still good.
The Airflow comes up from under the coils and into your face producing amazing flavor and cloud production.
- Dual Negative Posts Built into Deck
- Philips Head Center Post Screws
- Deep Juice Well
- Adjustable Air Cyclops Inlets
- Heat Sink Top Cap
- Three Piece Design
- 22mm Diameter
- 18 Degree Air Holes to create Vortex inside the barrel
- Silver Coated Contact Pin
Grab a Mutation X V4 for around $25.00
MarsTeam Japan Thruster RDA
The MarsTeam Japan Thruster RDA is a beauty of a Dripper. To start the build deck is wide open. Add in the tall posts and you have all the room you will need to build the ugly coils we all started out building.
With 6 cyclops air slots around the cap measuring 8mm, 6mm, and 4mm for adequate airflow adjustment. They added a copper 510 connection for superb conductivity. Hope you like a wide bore drip tip because the Thruster RDA has a 11mm Conp bore drip tip. If not then you can use the Stainless steel 510 Drip tip fitment
- Dual Adjustable Triple Stacked Airflow
- Three Post Build Deck
- Sleek Curved Design
- 11mm Competition Bore Drip Tip
- and Stainless Steel 510 Drip Tip Fitment
- Copper 510 Connection
- 2mm Diameter Terminals
- 24.5mm Diameter
Pick up a MarsTeam Japan Thruster RDA for around $70.00 (ok this one was not cheap)
You want to make sure you learn up on Coil building safety, Basic coil builds and other must have info. Below are some links to keep you going